Open “device manager” and check which COM port the USB interface is set to. If there are faults as described in Troubleshooting, set the port manually:
Vag k can commander 1.4 installation install#
VAG K+CAN COMMANDER USB interface is detected automatically, but you can install it and The checkboxes switch the protocols used when performing standard diagnostic queries, they K-Line - KWP2000/KWP1281 connection with device using “KWP1281 or KWP2000” protocol
CAN TP1.6 – connection to the device using the protocol “KWP2000 over TP1.6 with baud 5000KB/s” CAN TP2.0 – connection to the device using the protocol “KWP2000 over TP2.0 with baud 5000KB/s” VAG K+CAN COMMANDER can be configured by pressing the “Options” button.Ĭhanges to interface discovery and timing settings will be applied after a restart You can select one of these protocols as described in the "configuration" section KWP1281 or KWP2000 over K Line (protocol is set by default). VAG K+CAN COMMANDER will tryĬonnect to the device using the following protocols in sequence: If you want to connect with one of them, double click on it. – Special functions:, login (PIN), read EEPROM, etc.Īll units that can be installed in the vehicle are listed on the main screen, with their number. – Standard diagnostic functions: Read/Erase error codes, device identification,Īdaptation, measurement of parameters, etc… Run the program only from the folder with the installed software! Nothing is written, see Troubleshooting section. If the screen says “Interface Found”, your interface should work. To start working with the device you need:
0 kommentar(er)
